Wells Ventilation Hood WVSW VENTLESS HOOD User Manual

531  
WELLS BLOOMFIELD, LLC  
2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439  
telephone: 775-689-5703  
fax: 775-689-5976  
OWNERS MANUAL  
MODEL  
WVSW  
VENTLESS  
HOOD  
For  
CONVEYOR  
WARMERS  
Includes  
INSTALLATION  
USE & CARE  
SERVICE  
IMPORTANT: DO NOT DISCARD THIS MANUAL  
This manual is considered to be part of the appliance and is to be given to the OWNER or  
MANAGER of the restaurant, or to the person responsible for TRAINING OPERATORS of  
this appliance. Additional manuals are available from your WELLS DEALER.  
THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR  
INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any  
questions concerning installation, operation or maintenance of this equipment.  
PRINTED IN UNITED STATES OF AMERICA  
p/n 305812 Rev. B  
ECN-13380  
M531 071101 cps  
 
INTRODUCTION  
1
 
WVSW VENTLESS HOOD  
Fig. 1 Features & Operating Controls  
2
 
ITEM  
DESCRIPTION  
CANOPY  
Removable canopies aid in vapor capture at entry and exit of the conveyor  
warmer. Canopies hang from mounting pins at each end of the hood.  
ELECTRICAL  
EXHAUST  
The hood plugs into a NEMA 5-15R (120V) or 6-15R (208/240V) receptacle  
with a 6' power cord. An illuminated power switch on the front panel is used  
to start/stop the hood fan.  
The hood uses an exhaust fan to provide air movement. The fan exhausts  
through a screened opening in the top of the hood.  
IMPORTANT: DO NOT block exhaust opening.  
FILTERS  
The hood uses two filters. A high efficiency filter is used to capture  
particulate emissions.  
A charcoal filter is used to help control odors.  
Filters are accessed by opening a hinged panel on the front (operator's)  
side of the hood.  
Filter operation is monitored by a vacuum switch. When the filter(s)  
become loaded to the point of being unable to remove particulates, a front  
panel "change filters" indicator will glow.  
NAMEPLATE  
TOP PANEL  
Provides Manufacturer, Model and Serial Number information.  
Also, provides electrical ratings.  
CAUTION!  
ELECTRIC SHOCK HAZARD  
EXPOSED ELECTRIC CIRCUITS  
Top panel must be opened ONLY by qualified personnel.  
Allows access to interior components.  
DO NOT stack anything on top of the hood.  
AGENCY LISTING INFORMATION  
This appliance conforms to NSF Standard 4 for sanitation only if installed  
and maintained according to the instructions in this manual.  
STD 4  
This appliance is  
This appliance is  
Listed for 120V and 208 - 240V.  
Listed for 120V and 208 - 240V.  
IMPORTANT: For use with conveyor warmer of 9,000 watts maximum.  
NOTE: This ductless hood has not been evaluated to the requirements of  
NFPA 96.  
Local jurisdictions may require additional evaluations for installation  
of this product.  
3
 
4
 
5
 
6
 
7
 
8
 
TROUBLESHOOTING SUGGESTIONS  
SYMPTOM  
PROBABLE CAUSE  
CORRECTIVE ACTION  
Plug cord into appropriate power  
receptacle.  
No operation, no lights  
Cord unplugged  
Circuit breaker off or tripped  
Damaged power cord or plug  
Damaged power switch  
Filters dirty  
Reset circuit breaker  
Replace power cord  
Replace power switch  
Replace filters  
REPLACE FILTER light remains  
lit (never shuts off)  
If filters are clean  
and fan is operating  
New filter still in plastic wrapper  
Exhaust opening blocked  
Filter opening blocked  
Vacuum hose kinked  
Vacuum line plugged  
Damaged vacuum switch  
Fan jammed  
Remove plastic wrapper  
Clear or clean exhaust duct and  
opening  
Clear filter opening  
Unkink vacuum hose  
Clean or replace vacuum line  
Replace vacuum switch  
Unjam fan  
If fan is not operating  
Damaged motor start capacitor  
Damaged fan motor  
Replace start capacitor  
Replace fan motor  
9
 
10  
 
IMPORTANT: Use only  
factory authorized service  
parts and replacement  
filters.  
For factory authorized  
service, or to order factory  
authorized replacement parts,  
contact your Wells authorized  
service agency, or call:  
Wells Bloomfield, LLC  
2 Erik Circle  
P. O. Box 280  
Verdi, NV 89439  
Service Parts Dept.  
phone: (775) 689-5707  
fax:  
(775) 689-5976  
Service Parts Department can  
supply you with the name and  
telephone number of the  
WELLS AUTHORIZED  
SERVICE AGENCY  
nearest you.  
11  
 
Commercial Food Equipment Service Association  
Wells Bloomfield proudly supports CFESA  
Commercial Food Equipment Service Association  
SERVICE TRAINING -- QUALITY SERVICE  
Genuine Parts  
Protect - YOU - All - Ways  
CUSTOMER SATIISFACCTION  
WELLS BLOOMFIELD, LLC  
2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439  
telephone: 775-689-5703  
fax: 775-689-5976  
PRINTED IN UNITED STATES OF AMERICA  
 

Weslo Treadmill WLTL39093 User Manual
West Bend Fondue Maker ELECTRIC FONDUE POT User Manual
Westinghouse Microwave Oven WCM770B W User Manual
Whirlpool Clothes Dryer WGD9200SQ0 User Manual
Whirlpool Microwave Oven AMW 440 User Manual
Wilton Cordless Saw JWBS 16B User Manual
Yamaha Electronic Keyboard EZ J200 User Manual
Zanussi Clothes Dryer TD 100 User Manual
Zanussi Freezer 42FF User Manual
Zanussi Oven ZUF 270 User Manual