Whistler Home Security System WIC 2409C User Manual

Wireless Inspection Camera  
with Color LCD Monitor  
Model No.: WIC-2409C  
The Whistler Group Corporate Headquarters  
3604 NW Frontage Rd. Bentonville, AR 72712  
Tel 479.273.6012 • Fax 479.273.2927  
Customer Return Center  
551 N. 13th St. Rogers, AR 72756  
Customer Service Tel 800.531.0004  
Version No.: 1.0  
Please read this User Manual carefully before using the product!  
 
Thank you for choosing our wireless inspection camera. Please read the  
user manual carefully before using this product. This product is designed  
as a remote inspection device. It can be used to look into tight spots and  
wirelessly transmit real-time video to the monitor. Typical applications  
include HVAC, automotive inspection, cable routing, etc.  
If you have questions concerning the operation of this Whistler product,  
please call:  
Customer Service  
1-800-531-0004  
Monday - Friday • 8:00 am - 5:00 pm CT  
or visit our website:  
www.whistlergroup.com  
Please keep the receipt in a safe place.You may register your product online at  
store receipt must accompany any unit sent in for warranty work. If the unit  
is returned without a dated store receipt, an out of warranty service charge  
applies. Note: Your warranty period begins at the time of purchase. The  
warranty is validated only by dated store receipt! Please record the serial  
numbers (located on the back of the monitor and inside the grip’s battery  
compartment door) in the space provided in the warranty section of the manual.  
Enjoy your Whistler Inspection Camera.  
Sincerely,  
The Whistler Group, Inc.  
 
9mm Camera with  
3 ft. tube  
Handheld Grip  
2.4 in. LCD Monitor  
Mirror Accessory  
Clip  
Magnet Accessory  
Clip  
Hook Accessory  
Clip  
Accessory Collar  
Adapter Cable  
Power Adapter  
- 2 -  
 
COMPONENTS / CONTROLS  
- 3 -  
 
3. Reinstall battery compartment, cover, and screw.  
Finger tighten  
the knurled knob  
- 4 -  
 
The three included accessories (mirror, hook, and magnet) all attach  
to the camera (image head) in the same manner. Slide the accessory  
through the plastic holder, aligning it with the notch in holder.  
Engage the “hook” on the accessory end with hole in the camera head.  
Slide the plastic holder onto the camera head until it clicks to lock.  
Hole  
Accessory  
Notch  
Image head  
Plastic Holder  
Slide Plastic Holder  
onto image head  
Accessory Installed  
Align monitor slot with connector on grip and slide monitor downward  
for proper engagement.  
Align the slot  
and connector  
properly.  
Make sure metal  
tab engages  
properly.  
- 5 -  
 
Plug the adapter cable into the power socket on the monitor, plug the  
other end of the adapter cable into the end of the power adapter. Plug  
the power adapter into a 110v AC outlet.  
The built-in Li-battery will charge after the adapter is plugged in.  
The red indicator light will illuminate during charging and will turn off  
after charging is complete.  
The monitor can be used while charging.  
- 6 -  
 
Do not immerse the grip and monitor in water. Store in a dry place.  
Such measures reduce the risk of electric shock and damage.  
The imager head and cable are water resistant when the unit is fully  
assembled, but the grip and monitor are not.  
Rotate the ON/OFF switch to turn on the camera. The power indicator  
on top of the grip will illuminate. The intensity of the LEDs that surround  
the camera on the imager head can be adjusted by rotating the switch.  
- 7 -  
 
Slide the ON/OFF switch to the ON position. The power indicator will  
illuminate green and a picture will appear on the monitor when the handheld  
unit is turned on. Adjust the brightness, contrast, and orientation. Adjust the  
camera LED intensity for a better image.  
The switch acts  
as a dimmer.  
Gently guide the tube into the desired location. Slight adjustments can  
be made while maneuvering the head in a forward direction.  
The flexible tube can be bent to accommodate exploration in a  
variety of locations.  
The accessories can be  
used to retrieve small items  
such as screws or rings.  
- 8 -  
 
640 x 480 (NTSC)  
8V-36VDC  
490mA  
- 9-  
 
Do not expose the monitor or grip to dripping or splashing liquids.  
Turn off the camera and monitor when not is use.  
Use only the AC adaptor and cable supplied with the unit.  
Remove the batteries when cleaning the unit.  
Remove the batteries before storing the unit for a long time.  
When necessary, REPLACE ALL FOUR BATTERIES in this unit with new ones.  
Use only the size and type of battery specified.  
Be sure to install the batteries with the correct polarity as indicated on the  
battery compartment.  
Properly dispose of the batteries. Exposure to high temperatures can cause  
the batteries to explode. Do not dispose of batteries in a fire. When stored,  
place tape over the terminals to prevent direct contact with other objects.  
Some countries have regulations concerning battery disposal. Please follow  
all applicable regulations.  
- 1 0 -  
 
WARRANTY INFORMATION  
Consumer Warranty  
This Whistler Inspection Camera is warranted to the original purchaser for a period of one year from  
the date of original purchase against all defects in materials and workmanship.This limited warranty is  
void if the unit is abused, modified, installed improperly, or if the housing and/or serial numbers have  
been removed.There are no express warranties covering this product other than those set forth in this  
warranty. All express or implied warranties for this product are limited to the above time.Whistler is not  
liable for damages arising from the use, misuse, or operation of this product. During the warranty  
period, defective units will be repaired without charge to the purchaser when returned with a dated  
store receipt to the address below. Units returned without a dated store receipt will be handled as  
described in section "Service Out of Warranty".  
Note: Damage caused by incorrect battery placement or battery leakage is not covered under this warranty.  
When returning a unit for service, please follow these instructions:  
1. Ship the unit in the original carton or in a suitable sturdy equivalent, fully insured, with return receipt  
request to:  
Whistler Repair Dept.  
551 N. 13th St.  
Rogers, AR 72756  
Please allow 3 weeks turnaround time.  
Important:Whistler will not assume responsibility for loss or damage incurred in shipping.  
Therefore, please ship your unit insured with return receipt requested. CODs will not be accepted!  
2. Include with your unit the following information, clearly printed:  
Your name and street address (for shipping via UPS), a daytime telephone number and an email  
address, if applicable.  
• A detailed description of the problem (e.g.,“Cannot adjust brightness on monitor").  
• A copy of your dated store receipt or bill of sale.  
3. Be certain your unit is returned with its serial number. For reference, please write your unit’s  
serial numbers in the following spaces: Monitor S/N:  
Grip S/N:  
Units without serial numbers are not covered under warranty. Important:To validate that your unit is  
within the warranty period, make sure you keep a copy of your dated store receipt.You may register  
your dated store receipt must accompany any unit sent in for warranty work.  
Service Out of Warranty  
Units will be repaired atout of warrantyservice rates when:  
The unit’s original warranty has expired.  
• A dated store receipt is not supplied.  
The unit has been returned without its serial number.  
The unit has been abused, modified, installed improperly, or had its housing removed.  
The minimum out of warranty service fee for your Whistler Inspection Camera is $75.00 (U.S.). If you  
require out of warranty service, please return your unit as outlined in the sectionService Under  
Warrantyalong with a certified check or money order for $75.00. Payment may also be made by  
MasterCard,VISA, or American Express; personal checks are not accepted. In the event repairs cannot  
be covered by the minimum $75.00 service fee, you will be contacted by a Whistler technical service  
specialist who will outline options available to you. If you elect not to have your unit repaired, it will be  
returned to you along with your certified check or money order.  
- 1 1 -  
 
ACCESSORIES  
ORDER#  
DESCRIPTION  
PRICE  
WIC-100P  
Accessory Pack  
$99.95  
includes hard case, 3 ft. extension shaft,  
and magnetic swivel mount  
- 1 2 -  
 
FCC ID: TW5GB8802-GB8803  
Note: Changes or modifications not expressly approved by Whistler  
could void the user’s authority to operate the equipment.  
 

Weed Eater Trimmer 545167695 User Manual
Weslo Hot Tub WLHS42080 User Manual
Weslo Treadmill WLTL193060 User Manual
Westinghouse Mixer WST2009ZE User Manual
Whirlpool Refrigerator WRT138TFYB User Manual
Whistler Radar Detector 1640 User Manual
Yamaha Automobile Parts 14B 28199 11 User Manual
Zanussi Cooktop ZGL 62 ITX User Manual
Zanussi Oven 237004 User Manual
Zenith Flat Panel Television Z47LC6DF User Manual